Click to Subscribe
Register | Log in

Ford Ranger BCM

Return to: Vehicles & Technical

Come chat with us in the forum. Click here to register an account or if you are already registered click here to log in.

  • JD leyds
    dillon joosteParticipant

    Ford Ranger & BT 50 owners experiencing the following symptoms low beams not working and I have the error U3000 and U1000

    No need to replace the body control module at the agents

    Can be fully repaired

    Attachments:
  • mike webb
    mike webb
    mike webb on

    hi who fixing them and what price

    JD leyds
    dillon jooste
    dillon jooste on

    Hi Mike

    Welcome to contact me I do the repairs

    Price R2500

     

    Kind Regards

     

    • This reply was modified 2 years, 10 months ago by JD leydsdillon jooste.
    mike webb
    mike webb
    mike webb on

    Hi Dillon

    Please could you send me your number.

    regards

    Mike 0732503914

     

    Joes Magretse
    Joes Magretse
    Joes Magretse on

    Hello Dillon,

    Name is Joes Magetse – I own a 2015 Ford Ranger – Wildtrack. I have the BCM problem too. It has been replaced twice. you may help share your details at jmagetse@gmail.com

    If its not headlights deem, its headlights or one of the rear lights. MINE IS ON BRIGHT, NO DEEM.

    Joes Magetse +267 71 58 60 02 (WhatsApp)

     

    JD leyds
    dillon jooste
    dillon jooste on

    Welcome to contact me on 082 661 2120 for Ford BCM repairs

    JD leyds
    dillon jooste
    dillon jooste on

    The BCM in the Ford Ranger / Mazda BT50 runs a solid-state circuit protection system that monitors the load and resistances of the vehicles electrical system. If an abnormality is detected the BCM cuts any circuit outside its tolerance. When a fault is detected it triggers a counter in the BCM that can only happen a limited amount of times before the BCM cuts out the left-hand side low beam and or high beams permanently and in some cases, communication with the BCM is lost. In the case where the BCM has been identified as the issue the only option for the technician is to replace the BCM, This would require programming to the vehicle using an appropriate dealer scan tool, up until now this was a dealer only operation.

    JD leyds
    dillon jooste
    dillon jooste on

    I have a repair solution for the high beam lights also not working looking at R2800 for this repair on these BCM2’s

Viewing 7 replies - 1 through 7 (of 7 total)

Come chat with us in the forum. Click here to register an account or if you are already registered click here to log in.